Maytag MAH-24 Use & Care Manual page 13

The washer will not start
Make
Make
Make
Make
sure door is firmly closed.
sure the washer is plugged in.
sure the water source faucet is turned on.
sure to press the Start/Pause pad.
No water or insufficient
water supply
Detergent remains in the
automatic dispenser after the
wash cycme is compmete
Washer vibrates or is too noisy
Stops
Make sure the Child Lock is not activated, see page 6.
Turn both faucets on fully.
Make sure the door is tightly closed.
Make sure the washer is plugged in.
Check fuse or reset circuit breaker.
Press the Start/Pause pad.
Straighten water inlet hoses.
Disconnect hoses and clean screens. Hose filter screens may be plugged.
Open and close the door, then press the Start/Pause pad.
Make sure the washer is running with sufficient water pressure.
See Installation Instructions.
Put the detergent in the inner parts of the dispenser
(away from outside edges).
Make sure the washer is set on a level surface. If the surface is not level,
adjust the washer feet to level the appliance.
See Installation Instructions.
Make sure that the shipping bolts are removed.
See Installation Instructions.
Make sure the washer is not touching any other object.
Make sure the laundry load is balanced.
Plug cord into live electrical outlet.
Check fuse or reset circuit breaker.
Close door and push the StartiPaese pad to start the washer.
For your safety, the washer will not tumble or spin unless the door is
closed.
This may be a pause or soak period in the cycle.
Wait briefly and it may start.
Check screens on inlet hoses at the faucets for obstructions.
Clean screens periodically.
Continued...
12