Extron electronics YCS 100 User Manual page 15

Installation and Operation, cont'd
Figure 2-15 — Jumper on YCS 100 internal board
When the YCS is delivered from the factory, a shunt is
N
attached to one prong of the jumper. This shunt is used
to enable the jumper in step 4.
4. Enable (close) the CR8 jumper by placing the shunt on both
prongs, as shown below.
Open
Figure 2-16 — Enabling the CR8 jumper
5. Replace the YCS cover, using the screws that you removed.
6. Connect and power on all attached devices, then power on
the YCS 100.
2-16 YCS 100 • Installation and Operation
Closed
YCS 100
A
A ppendix A
Specifi cations, Part Numbers,
and Accessories
Specifi cations
Included Parts
Accessories