Maytag MTB1504ARW Use & Care Manual page 5

Installation
15. Carefully place freezer door on top of hinge arm.
Use foam door spacer to set gap.
Reversing Doors
Tools Required:
• Phillips screwdriver
• 5/_6" s ocket and ratchet
• 5/,,, end wrench
• Putty knife
Unplug the refrigerator.
1. Remove the hinge cap and set aside.
2. Remove screws from the upper hinge with a 5/,,,
socket and ratchet and set aside.
3. Carefully lift and remove freezer door (including the
upper hinge) off the center hinge.
4. Remove screw and hinge arm from top of the
refrigerator door.
5. Carefully lift and remove refrigerator door.
6. Remove front base grille and set aside.
7. Remove hinge plate from lower corner of
refrigerator and secure it on the opposite side.
8. Remove the plate from the underside of the
refrigerator door and secure it on the opposite side.
9. Remove the plate from the underside of the freezer
door and secure it on the opposite side.
10. Remove the plug button(s) from tops of freezer and
refrigerator doors and replace them on the
opposite side.
11. Remove screw hole plugs from top of cabinet and
replace on the opposite side.
12. Remove washers and stem from the inside of the
hinge plate and place them on the outside of the
hinge plate.
13. Carefully replace refrigerator door on the hinge
plate in lower corner.
14. Slide the hinge arm into place and secure with
screw.
Note
• Do not discard the foam door spacer. Doors may
settle with use.
16. Slide top hinge into place on freezer door and
secure screws with _/,5"wrench.
Confirm that all screws have been tightened securely.
17. Snap hinge cap securely in place.
18. Replace front base grille.
Remember to plug in your refrigerator and reset the
controls to the appropriate setting(s).