Before Using Your Vcr - Philips VRX344AT Owner's Manual

Before Using Your V CR5
Putting Batteries in the Remote Control •
!
Remove the battery compartment lid on the bottom of the
remote control by pressing in the tab, then lifting the lid.
2
Place two AA batteries inside the battery compartment
with their polarities (+ and - ends) aligned as indicated.
3
Replace the battery compartment lid.
Using the Remote Control
• Point the remote control at theVCR's remote sensor (see page
27) when using the remote control to operate the VCR. Point
the remote control at the TV when using the remote control to
operate the TV. Point the remote control at the Cable Box or
Digital Satellite System when using the remote control to oper-
ate the Cable Box or Satellite System.
• Do not put objects between the remote control and the VCR.
• Before you use the remote control to operate yourVCR, you
must first press theVCR button.
• Before you use the remote control to operate yourTV, you
must first press the TV button.
• Before you use the remote control to operate your Cable Box
or Digital Satellite System, you must first press the CBL/DSS
button.
Erasure Prevention
Video cassette tapes have record tabs to ensure that recordings
are not accidentally erased.
I
To prevent accidental erasure, break off the tab with a
screwdriver.
2
To record again, cover the hole with cellophane tape.
I
VCR maintenance
• In thisVCR, use only tapes with the _ marl_
• Make sure any light adhesive stick-on notes are removed from
the video cassette tape before putting the tape in the VCR.
Removable labels like these can jam the VCR.
• Periodic maintenance is required to maintain yourVCR's excel-
lent performance.This VCR has an Automatic Head Cleaner.
However, the video heads will eventually require replacement,
which should be performed only by an authorized service cen-
ter.
Helpful Hints
• The remote control and its batteries
are supplied.
• Do not mix alkaline and man-
ganese batteries.
• Do not mix old and new batteries.