Before Using Your Vcr 5 - Philips MVR440MG Owner's Manual

Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the bottom of
the remote by sliding the lid in the direction of the arrow.
2
Insert two AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
3
Replace the battery compartment lid.
Using the Remote Control
Point the remote at the VCR's remote sensor (see page 21) when
using the remote to operate the VCR.
Do not put objects between the remote and the VCR.
Recording Prevention
Videotapes have record tabs to ensure that recordings are not
erased accidentally.
1
To prevent recording, break off the tab with a screwdriver.
2
To allow recording, cover the hole with cellophane tape.
VCR maintenance
In this VCR, use only tapes with the
Make sure any light adhesive stick-on notes are removed from
the videotape before putting the tape in the VCR. Removable
labels can jam the VCR.
Periodic maintenance is required to maintain your VCR's excellent
performance.This VCR has a built-in Automatic Head Cleaner.
However, the video heads will require replacement eventually. Only
an authorized service center should perform this service.

Before Using Your VCR 5

mark.
1
2
3
1
2
Helpful Hints
• Do not mix alkaline and man-
ganese batteries.
• Do not mix old and new batteries.