Philips VRX344AT Owner's Manual page 35

Timer R ecording (cont'd) 3 5
4
Use the Number buttons (I - 8) to select a slot in which
to store the timer recording. There are eight timer recording
slots. Open slots will flash on-screen.
NOTE: If you enter a number for a slot that has already been used to
store a timer recording, PREVIOUSLYSETPROGRAM will appear on-
screen for a few seconds.Then information about the program in that
slot will be displayed on-screen. If this happens, press the STATUS/EXIT
button twice.Then start again at step I.
5
Enter the channel you want to record.
• If you have a basic antenna or cable hookup (as shown on pages
six.-seven) enter the channel of the TV program you want to
record. (You must enter a 0 before all single digit channels.)
• If you are recording from line input, press 0, 0. AV REAR will
appear on-screen.
• If you are using a Cable Box/DSS Receiver, enter the Cable
Box/DSS Receiver output channel (channel 03 or 04). See page
eight for details.
,
CORRECT PUSH CLEAR
qD PUSH EXIT
6
E TIME PROGRAM
OGRAM I
HANNEL 10
IME ON - - .-
CORRECT PUSH CLEAR
END PUSH EXIT
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press I for AM
or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.
7
Enter the recording's stop time.
Follow the instructions in step 6 to set the recording's stop time
(AM or PM will be set automatically).
E TIME PROGRAM 1
,OGRAM I
ANNEL 10
E ON 09.30 PM
ME OFF .....
CORRECT PUSH CLEAR
END PUSH EXIT
Instructions continue on page 36.
47
. Helpful Hin
• You must leave the Cable BoxlDSS
Receiver turned on for a timer
recording (if applicable).
• Entries that do not match the VCR's
internal clock or calendar will cause
a question mark (?) to appear on-
screen.