LIFESTYLER Extend 10.0 Owner's Manual page 12

b. If an extension cordis needed, u seonlya 14-gauge general-purpose cordoffivefeetor lessin length.
c. If the walkingbelt is overtightenedo treadmill p erformance
maydecreaseand the walkingbelt maybe permanently
damaged. Removethe safetykey and UNPLUGTHE
POWERCORD. Usingthe allenwrench,turn both rear
rolleradjustmentboltscounterclockwise, 1 /4of a turn.
Whenthe walkingbelt is properlytightened, y ou should
be able to lift eachsideof the walkingbelt3-4 inchesoff
the walkingplatform. The centerof thewalkingbelt
shouldjust touchthe walkingplatform. Be carefulto
keepthe walkingbelt centered. Plugin thepowercord,
insertthe safetykey and runthe treadmillfora few min-
utes. Repeatuntilthe walkingbelt is properlytightened.
RearRoller
AdjustmentBolts
5. SYMPTOM:THE WALKtNGBELTIS OFF-CENTER ORSLIPSWHENWALKED ON
a. If the walkingbelt has shiftedto the left,first removethe
safetykey and UNPLUGTHE POWERCORD. Using
the allen wrench,turn the left rear rolleradjustment b olt
clockwise,and the right bolt counterclockwise, 1/4of a
turn each. Be carefulnot to overtightenthe walkingbelt.
Plugin the power cord, insertthe safetykey andrun the
treadmillfor a few minutes.Repeatuntilthewalkingbelt
is centered.
a
b. If the walking belt has shifted to the right, first remove the
safety key and UNPLUG THE POWER CORD. Using
the allen wrench, turn the left rear roller adjustment bolt
counterclockwise, and the right bolt clockwise, 1/4 of a
turn each. Be careful not to overtighten the walking belt.
Plug in the power cord, insert the safety key and run the
treadmill for a few minutes. Repeat until the walking belt
is centered.
b
L
c. If the walking belt slips when walked on, first remove the
safety key and UNPLUG THE POWER CORD. Using
the allen wrench, turn both rear roller adjustment bolts
clockwise, 1/4 of a turn. When the walking belt is correctly
tightened, you should be able to lift each side of the walk-
ing belt 3-4 inches off the walking platform. The center of
the walking belt should just touch the walking platform.
Be careful to keep the walking belt centered. Plug in the
power cord, insert the safety key and run the treadmill for
a few minutes. Repeat until the walking belt is properly
tightened.
STORAGE
C
Unplug the power cord when the treadmill is not in use. Remove the bolts and washers from the upper
ends of the left and right handrails. Rotate the handrails downward. Remove the front bolt and washer
from the lower end of each handrail (see assembly steps 1 and 2 on page 6 for reference). Lay the
handrail on the walking belt. It is recommended that the,!reada3iU be covere d during extended p erigds
of storage.
11