Advertisement
HOW TO DISASSEMBLE AND ASSEMBLE
2. HANDLE
1) Put blade screwdriver
into a groove on the side of a
Deco handle and lift up a little bit in arrow O direction
and push up with hand in arrow _) direction and
disconnect.
4) Disassembly
of a grille fan (L) : Hold upper part of a
gdIle fan(L) and pull forward carefully.
5) Loosen two screws.
6) Disassembly
of shroud. F(U) : Disconnect
housing of B
after removing two rail guides with a blade screwdriver.
7) Disassembly
of shroud. F(U) : Hold upper part and pull
forward.
8) Check foam PU sticking conditions
around a shroud,
F(U) and F(L) during assembling.
If damaged,
torn or
badly sticked, aasemble with a new one after sealing
well.
Handle, Deco
\
2) Put blade screwdriver
into e groove on the side of a
DECO handle and lift up in arrow direction (_) and push
down with hand in arrow direction _) and disconnect.
3) Push up a piece handle (_ in arrow direction with hand
and disconnect.
4) Turn screw in arrow direction with a cross driver and
disconnect.
Screw
Handle, Piece
3. SHROUD,
GRILLE
FAN
1) Loosen two screws after disconnecting a cap screw of a
grille fan(U) with a balde screwdriver,
2) Disassembly of a gdlfa fan(U) : Pull forward after
opening hook at
. part with a blade screwdriver.
3) Disconnect housing (_ of a grille fan (L) from the main
body.
4. ICEMAKER
ASSY
1.
Dispenser
Model
1) How to disassemble:
(1) Remove ice bank from the freezer compartment.
(2) Loosen two screws on the upper part of icemaker
bracket.
(3) Disconnect icemaker bracket so that it can slide
forward.
(4) Disconnect
icemaker housing and sensor housing.
(5) Disconnect
icemaker horizontally
by pressing bracket
hook part. ( Don't disassemble
further, The set value
may be changed.)
2) How to assemble : The assembly
is the reverse order of
the above disassembly.
Bracket, Ice_
Ice Maker Unit
"_,N_._
ever
Sensor
Cover, Sensor
Note : When the ice tray is not horizontal after assembly,
assembly must be wrong. Check and assemble
again.
- 10,5 -
Advertisement
