Advertisement
HOW TO INSTALL REFRIGERATOR
3, When customer
uses bottled water,
*If customer wants to use bottled water, extra pump should be installed as shown below.
1. The pump system should not be on the floor (it may cause noise and vibration). Securety fasten the inlet and outlet
nuts of pump.
2. If there is any leakage alter installation,
cut the water tube at right angle and reassemble.
3. When put the water tube end into the bottle, leave a clearance between
bottle bottom and water tube end.
4 Check water coming out and any leakage.
Caution : • If feed tube is more than 4m, less water will come out due to pressure drops.
• Use standard feed tube to prevent leaking.
f"
N
• Outternal
Filter
t. Filter Fixation
1) Connect feed tube to the filter outlet and water valve connecting
tube,
2) Fix the filter at proper place around the sink where it is easy to replace the filter and to receive the cleaning water,
Please consider the length of tube shall be less than 12m when locating filter.
3) When fixing the filter, use fixing plate and cable depending on the surrounding conditions.
FixingCable _
FixingPlate
Fixing Plate
•
"J
2. Filter Cleaning
t) Connect feed tube to the inlet of feed valve end filter.
2) Clean the main valve and feed valve with water for at
least one minute until clean water comes out.
-21 -
Hot Water
Cold Water
Filter Inlet
Filter_
Water
Advertisement
