Plan Vent System - KitchenAid YKEHS01P Use & Care Manual

Plan Vent System
Typical exhaust installations
Typical installations vent the dryer from the rear of the dryer.
Other installstions are possible.
A. Dryer
B. Elbow
C. Wall
D. Exhaust hood
A m
B
_H
E. Clamps
E Rigid metal or flexible metal vent
G. Vent length necessary to connect elbows
H. Exhaust outlet
Optional exhaust installations
This dryer can be converted to exhaust out the right side, left
side, or through the bottom. Contact your local dealer to have the
dryer converted.
Fire Hazard
Cover unused exhaust holes with one of the
following kits:
279818 (white)
280028 (meteorite)
Contact your local dealer.
Failure to follow these Inatructlons can result In death,
fire, electrical shock, or serious Injury.
Alternate installations for close clearances
Venting systems come in many varietiea. Select the type beat for
your installation. Two close-clearance installations are shown.
Refer to the manufacturer's instructions.
ii I i _1
", J
A B
A. Over the top installation (also available with one
offset elbow)
B. Periscope installation
NOTE: The following kits for close clearance alternate
installations are available for purchase. Please see the
"Assistance or Service" section of this manual to order.
a Overthetop Installation:
Part Number 4396028
a
Periscope Installation (For use with dryer vent to wall vent
mismatch):
Part Number 4396037 - 0" ((3cm) to 18" (45.72 on)
mismatch
Part Number 4396011 - 18" (45.72 on) to 29" (73.66 cm)
mismatch
Part Number 4396014 - 29" (73.66 on) to 50" (127 cm)
mismatch
Special provisions for mobile home installations
The exhaust vent must be securely fastened to a noncombustible
portion of the mobile home structure and must not terminate
beneath the mobile home. Terminate the exhaust vent outside.
A B C
A. Standard tear offset exhaust installation
B. Left or tight side exhaust installation
C. Bottom exhaust installation (Not an option with
pedestal installationsJ
Determine vent length
1. Select the route that will provide the straightest and most
direct path outdoors. Plan the installation to use the feweat
number of elbows and turns. When using elbows or making
turns, allow as much room as possible. Bend vent gradually
to avoid kinking. Avoid 90° turns when possible.
14