Checking Your Vent - KitchenAid KGYS750GQ1 Use & Care Manual

Your dryer must be properly installed and vented to achieve maximum drying efficiency and shorten
drying times. Use the minimum recommended installation clearances (found in your Installation
Instructions) to avoid blocking the flow of combustion and ventilation air. Install your dryer in a well-
ventilated room where the temperature is always above 7°C (45°F). Also make sure that your dryer
is leveled. Refer to your Installation Instructions for more information.
Venting
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can
result in death or fire.
If the dryer is not properly installed and vented, it
will not be covered under the warranty.
NOTE: Service calls caused by improper venting
will be paid for by the customer, whether it was a
paid installation or self-installed. For paid installation,
call the company that installed the vent for
adjustment.
1. Do not use plastic vent or flexible metal foil vent.
10.16 cm (4 in)
length requirements of vent.
6

Checking Your Vent

wWARNING
Fire Hazard
Use 10.16 cm (4 in)
heavy metal or flexible
metal vent. Do not kink
or crush flexible metal
vent. It must be com-
pletely extended to
allow adequate exhaust
air to flow. Check vent
after installation. Refer
to your Installation
Instructions for proper
2. Use a 10.16 cm (4 in) exhaust hood. Smaller
10.16 cm (4 in)
10.16 cm (4 in)
3. The exhaust vent can be routed up, down, left,
hoods increase drying
times.
right, or straight out the
back of the dryer. Space
requirements are listed
in your Installation
Instructions.