Table of Contents
Advertisement
Available languages
Available languages
3,
Remove the 2 screws that hold the handle bracket to the
door.
4.
Move hinge to the other side and reettach with the 4 screws
removed in Step 2.
5.
Move handle bracket to the other side and resttach with the 2
screws removed in Step 3.
6. Set the inner door assembly aside.
Reinstalling
the door
1. Check for fingerpit nts on the glass. Clean if necassary.
2.
Place the inner door assembly into the outer door assembly.
Align the hinge in the opening on the side. To fit correctly, the
inside door assembly edge is completely inside the outside
door assembly edge.
3.
Reassemble the inner and outer door assemblies with the
6 SCreWS.
4,
5.
Replace the 2 handle screws for the door handle of the door
assembly.
Use a small fiet-blade screwdriver to remove hole plugs in the
door opening. Slide the head of the screwdriver under the
cap of each hole plug, being careful not to scratch the dryer
surface. Lift up. Remove the hole plugs in the door opening
and insert in the opposite side.
6,
Insert a screw in the second opening from the top of the
hinge opening and partially tighten. Hang the door by placing
the top hinge keyhole over the second
screw head and
tighten the screw. By putting this screw in first, the door will
hang in place while you insert and tighten the remaining
4
SCreWS.
A. Dryer door
B. Dryer
C. Insert this screw first
7. Close the door and check that it latches securely.
Complete Installation
1. Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
2. Check to be sure you have all of your tools.
3.
Dispose of/recycle all packaging materials.
4. Check the dryer's final Iocetion. Be sure the vant is not
crushed or kinked.
5. Check to be sure the dryer is level. See "Level Dryer."
6.
Plug into a grounded outlet. Turn power on.
7.
Remove the blue protective film on the console and any tape
remaining on the dryer.
8.
Read "Dryer Use."
9. Wipe the dryer drum interior thoroughly with a damp cleth to
remove any dust.
10. Set the dryer on a full heat cycle (net an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
•
Controls are set in a running or "On" position.
•
Start button has been pushed firmly.
•
Dryer is plugged into a grounded outlet.
•
Electrical supply is connected.
•
House fuse is intact and tight, or circuit breaker has not
tripped.
•
Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the
dryer door and feel for heat.
If you do not feel heat, turn the dryer off and check the
following:
•
There may be 2 fuses or circuit breakers for the dryer. Check
to make sure both fuses are intact and tight, or that both
circuit breakers have not tripped. If there is still no heat,
contact a qualified technician.
NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
Page 17
Advertisement
Table of Contents
