Table of Contents
Advertisement
Installation, cont'd
Preparing the Table and Mounting the Enclosure
The preferred and recommended method for preparing the
table is to use the appropriate Extron routing template and a
router. The templates are available at no cost; see the part
numbers for the templates in appendix A, "Reference
Information".
For an HSA 200C, HSA 200CE, or HSA 222C unit (US version
only), another preferred method is to use a 6" hole saw.
Alternatively, for any model, you can use a paper cut-out
template (see a ppendix A, "Reference Information") and a
sabre saw or keyhole saw, but this method is not recommended.
The opening in the table for the HSA enclosure
CAUTION
should be cut only by licensed and bonded
craftspeople. Exercise care to prevent scarring or
damaging the furniture.
The routing templates for the various HSA models
are not interchangeable. If you use the wrong
template, you will cut an improperly-sized hole. If
you use a larger template than required, the cut will
result in gaps in the table surface on either side of
the enclosure.
The surfaces of the HSA enclosure have screws and
other protruding hardware that could damage fine
furniture. Do not rest the enclosure on unprotected
furniture.
Preparing the table with a router
1.
Locate the desired mounting location on the tabletop or
other installation surface. Mark the location.
2.
Place the mounting template assembly on the table,
centered on the mounting location. Angle the template for
the optimum positioning. If necessary, use a square to
ensure that the template is properly positioned. Extron is
not responsible for improperly-positioned HSA products.
Ensure that only the wooden strips contact the
CAUTION
furniture. Failure to do so may mar the furniture.
3.
Once the template assembly is positioned properly, secure
the assembly to the table with clamps (figure 2-2).
HSA 200/222 Series • Installation
2-4
Figure 2-2 — Cutting the opening with a router
(example)
4.
Using a router with a 5/8" (or 16 mm) outside diameter
guide bushing and a 1/2" (or 12 mm or 12.7 mm)
diameter straight router bit, carefully cut the opening in
the table surface (figure 2-2).
Wear safety glasses when operating the router.
Failure to comply can result in eye injury.
5.
Remove the clamps and the routing template.
The routing template is reusable. Do not discard the
template when the installation is complete. Save it to
install other HSA products of the same size.
HSA 200/222 Series • Installation
2-5
Advertisement
Table of Contents
