Installing The Anti-Tip Device - Kenmore 61011 Use, Care, Safety Manual

NormaD installation Bnstructions cont nued
$ :ep 9
Leveling the Range
1. Remove the storage drawer, broiler drawer or kick
panel°
2. Use a 3/16" open-end or sock- ./
et wrench to back out both f t_71 \
rear leveling legs approxi- _' I_
mately two turns, _ __ )
3. Use a 1%' open-end or _ r._.-.._
adjustable wrench to back out ",_ / -':_€"f
the front leveling legs two turns.. __ till II
4, Install the oven shelves in the ro_ !fti It
oveo pos tioo the1-i .. 0
range where it will be _ __j.-<_
5. Check for levelness by placing _.__
a spirit level or a cup, partially
filled with water, on one of the oven racks.. If using a
spirit level, take two readings--with the level placed
diagonally first in one direction and then the other.
6. Adjust the leveling legs until the range is level.
7. After the range is level, slide the range away from
the wall so that the Anti-Tip device can be installed.
t @
Installing the Anti-Tip Device
WARNING:
o Range must be secured with an approved Anti-
Tip device.
o Unless properly installed, the range could be
tipped by you or a child standing, sitting or lean-
ing on an open door,,
• After installing the Anti-Tip device, verify that it is
in place by carefully attempting to tilt the range
forward.
o This range has been designed to meet all recog-
nized industry tip standards for all normal condi-
tions,,
o The use of this device does not preclude tipping
of the range when not properly installed,
o tf the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB02X7909
'1. Mark the walt where the RIGHT EDGE of the range
is to be located. Be sure to allow for the countertop
overhang if you intend to install the range next to
cabinets
Approx 20,
1
_e_:Ant_'rip t
;ce !
t!i 'ii'°'e I
/"
,/
/ Marked Edge
,/
2,
3_
4.
,,-f
Locate the outside edge of the device 2W" toward the
center of the range from the marked edge of the
range.
Using the device as a template, mark the position of
the hole for the screw,
For wood construction, drill a pilot hole at an angle of
20 degrees from the horizontal, A nail or awl may be
used if a drill is not available,,
Mount the Anti-Tip device with the screw provided,,
For cement or concrete construction, you will need a
1/4" x 1½" lag bolt and a 1/2" O.D sleeve anchor,
which are not provided,, Drill the recommended size
hole for the hardware.
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device, The bolts
must be properly tightened as recommended for the
hardware.
Wallboard
Anti-Tip
Device
Wood Screw
Back of
Range
5. Slide the range against the wall, and check for
proper installation by grasping the front edges of
the rear surface unit openings and carefully
attempting to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL CONTROLS ARE LEFT IN
THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
12