Kenmore 61011 Use, Care, Safety Manual page 9

Step 4
Seal the Openings
Seal any openings in the wall behind the range and
in the floor under the range when hookups are
completed,
Adjust the Surface Burner Pilots If Necessary
1. Raise the cooktop,
Step 5
Light the Pilots (for models equipped
with Standing Pilots)
The range should be installed in its permanent posi-
tion before any pitots are lit or adjusted.
Light the Surface Burner Pilots
CAUTION: Make sure the surface burner control
knobs are in the "OFF" positions before attempting to
light the pilots.
1. Raise the cooktop.
2. Light both pilots with a match,.
3, To avoid pilot outage, use caution when closing
cooktop after lighting pilots,.
NOTE: Do not leave standing pilot lit in a newly con-
structed or remodeled home or apartment that will be
unoccupied for more than a month,
Each pilot flame was adjusted at the factory to be
approximately 5/16" tatlo A tinge of yellow appearing at
the upper tip is normal° if you find pilot adjustment is
necessary, follow instructions at right,
2_
=
Locate the pilot
adjustment screw° it can
be accessed through the
small hole near the center
of the manifold panel,
To adjust, use a blade-type screwdriver with a shaft
diameter of less than 3/16", Turn pilot adjustment
screw until pilot is 5/16" high, Do not reduce the
flame to less than 5/16" or pilot outage may occur.
A pilot flame burning higher than recommended
may generate soot (carbon black) on the bottom of
your cooktop,
Light the Oven Pilot
CAUTION: Make sure the OVEN CONTROL knob is
in the "OFF" position before attempting to light the
pilot,
1. Remove the broiler drawer by sliding the drawer all
the way out and then lifting slightly to remove it
from its tracks.
2_
8
Locate the pilot at the
back of the broiler
compartmentThe pilot
is attached to the left
side of the oven burner,
Light the pilot with a
match_ No adjustments are
required for natural gas,
For LP gas, see How to
Convert the Range for
Use with LP Gas or
Natural Gas.
(continued next page)
9