How To Convert The Range For Use With Lp Gas Or Natural Gas - Kenmore 61011 Use, Care, Safety Manual

How to Convert the Range for Use with LP Gas or NaturaUGas
Prepare Range for Conversion
CAUTION--Before converting the range:
(1) Turn off gas supply at the wall and
(2) Turn off the electrical power to the range.
tf range has not yet been connected to gas supply,
or if flexible connection was made, range may be
pulled out from the wall to make conversion easier.
Tools Required:
T-10 Torxdriver (for sealed burners)
I/2" and 3/4" open-end wrench
Flat blade screwdriver (small)
Nut drivers or wrenches: 7mm or 5/16"
(depending on the size of the spuds)
[
WARNING: Do not remove the pressure regulator from the range
Step t
Convert The Pressure ReguUator
1. For models equipped with sealed burners, remove
the storage drawer, broiler drawer or kick panel and
locate the pressure regulator at rear of the range
Remove Screws __._
Access Cover
On some models, you may have to remove an access
cover also
For models equipped with dual burners, remove the
cooktop and locate the pressure regulator at right rear
of range
2. Determine which figure, A or B, is appropriate for
your regulator type.
If it is regulator A:
1. Use a coin to remove the cap from the pressure reg-
ulator
2, Turn the cap over and hook it into the slots.
The type of gas to be used should now be visible on
the top of the cap.
If it is regulator B:
1. Unscrew the plastic-protected hex-nut cap from the
regulator
2. Carefully pry the protective plastic cap off
the threaded metal cap Gently pull the plastic wash-
er off the threads on the other side of the metal cap
3. Push the plastic cap onto the end of the metal cap
displaying the type of gas you are converting to_
Press the attached plastic washer onto the threads
on the other side of the metal cap
4. Screw the hex-nut cap back into the regulator. Do
not overtighten
Lever shown closed
_ ROTATE OPEN_
Lr__L_" _._ _ _Gas Flow _ ._
A ___.__/_..,)C8_D_ into Range __ _._ i / _. _._.4, _Ca p
___ NAT ///____
Note: On some models the shut-otf valve
may be in a different location
Lever shown closed.
PULL OPEN.
\
Gas Flow
into
Do not remove
this protective cap
except for conversion
Cap Assembly
Note: On some models the shut-off valve
may be in a different location
13