Optoma 3D-RF System User Manual page 3

LED Indicators
The Optoma 3D-RF Emitter uses 5 multicolored LEDs
to indicate modes of operation or other information.
The LEDs are located on the top of the emitter close
to the joystick and display red, green, or orange.
Joystick
The Optoma 3D-RF Emitter uses a joystick to allow
the user to enable various modes and change
settings. The joystick has two axes and a center
button function. Function of the axes and buttons
are dependent on the operating mode as described
in following sections.
Modes of Operation
The Optoma 3D-RF Emitter has 5 modes of operation.

Normal

Sync Signal Status (Strength)

Manual Tuning of Glasses Performance

Pairing the Optoma 3D-RF Emitter with Optoma 3D-RF Glasses

Set Polarity
Accessing Modes
During normal operation, the joystick is used to
access different modes of operation. Press and
hold the joystick to cycle through the available
modes. Release the joystick to select a mode. In
any mode, the normal mode of operation
resumes after 60 seconds of inactivity with the
exception of Set Polarity mode. Set Polarity mode
will time out in 10 seconds.
Copyright 2011 Bit Cauldron Corporation Page 3 of 24