Restoring Factory Defaults - Optoma 3D-RF System User Manual

Restoring Factory Defaults

Restoring a pair of glasses to factory defaults restores the factory default settings and firmware. This
includes putting the glasses in the unpaired mode. Any firmware or other settings on the glasses will be
reapplied by the Optoma 3D-RF Emitter upon restart of the Optoma 3D-RF Glasses.
To restore a pair of glasses to factory defaults, start with the glasses turned off.

Press and hold down the button

The LED will go on solid after 1 second; keep holding down the button

After about 10 more seconds the LED will start pulsing indicating that the glasses are ready to
pair; keep holding down the button.

After about 20 more seconds the LED will start blinking rapidly. Release the button now. The
glasses will restore the factory default settings and firmware. This can take several seconds.
After the process is complete, the glasses will resume normal operation.
If you do not release the button within 20 seconds after the LED begins rapidly blinking, the glasses will
power off.
Copyright 2011 Bit Cauldron Corporation Page 17 of 24