Optoma 3D-RF System User Manual page 10

Optoma 3d-rf glasses and optoma 3drf emitter

Hide thumbs Also See for 3D-RF System:

Table of Contents

3D Emitter & Glasses Pairing Mode: Pairing the Optoma 3D-RF Emitter with Optoma

3D-RF Glasses

The emitter may operate an unlimited number of glasses at any given time. However, the emitter may

choose to uniquely pair with a maximum of eight glasses.

After placing the Optoma 3D-RF Emitter in pairing mode, you will see the red "in-search-of-a-pair light

sequence" heartbeat.

The Optoma 3D-RF Emitter will remain in pairing mode for one minute. During that time, multiple

glasses may be paired with the Optoma 3D-RF Emitter. The only indication that pairing is successful will

occur at the glasses. When the Optoma 3D-RF Emitter cannot pair to any more devices, it will display the

"all available pairs already memorized" signal indicated by five red LED's blinking all-on and all-off for

ten seconds. The emitter will then return to normal operation. The device must be reset to factory

defaults to clear the memorized pair list.

Page 10 of 24

Table of Contents