Optoma 3D-RF System User Manual page 13

PC Upgrade
1. Connect the Optoma 3D-RF Emitter to a PC or Laptop with the Bit Cauldron upgrade software
installed
2. Follow the instructions that come with the Optoma 3D-RF System Management and Utility.
3. The Optoma 3D-RF Emitter will upgrade the Optoma 3D-RF Glasses by way of the RF link as
appropriate.
The center LED of Emitter is RED then it is in FW download mode. If joystick is pushed to any direction
when power is applied, the emitter will enter FW download mode. Make sure joystick is not stuck in any
position when power is applied. Remove the cover and make sure PCBA is mounted correctly if center LED
is RED when power is applied.
Copyright 2011 Bit Cauldron Corporation Page 13 of 24