Check Operation; Range Hood Use; Range Hood Controls - KitchenAid KHTU705 Use And Care Manual

This hood comes s tandard withanArchitect <_ S eries I Istainless
steel front t rimpiece. Toreplace thestandard front t rimpiece with
anoptional purchased front t rimpiece:
t. Reach i nside t hefront o fthehood and locate ahexnut
approximately 3"(7.6 cm) i nfrom bothoutside e dges.
2. Remove the7mmhexnuts.
For r ecirculating installations only, i nstall thecharcoal filters
included i nRecirculation KitPart N umber 4396565. Place t he
charcoal filter against theblower cover androtate t otheright
(clockwise) toattach t ocover. Repeat withother c harcoal filter.
A. Hood
B. Hexnut
C. Trimpiece
3. Pull the trim piece straight out.
4. Insert the studs on the back of the new trim piece through the
holes in the front of the hood.
5. Replace the hex nuts and tighten securely.
iNTERCHANGEABLE FRONT TRiM PART NO.
Architect ® Series - 30" Trim Kit
Stainless Steel 8212621
White 8212462
Black 8212463
Biscuit 8212461
Architect ® Series II - 30" Trim Kit
White 8212623
Black 8212624
Biscuit 8212622
Pro Line ® Series - 30" Trim Kit
Stainless Steel 8212464
Meteorite 8212465
Architect ® Series - 36" Trim Kit
Stainless Steel 8212625
White 8212467
Black 8212468
Biscuit 8212466
Architect ® Series II - 36" Trim Kit
White 8212627
Black 8212628
Biscuit 8212626
Pro Line ® Series - 36" Trim Kit
Stainless Steel 8212469
Meteorite 8212470
2,
A. Filter
Replace metal filter. Place back edge of metal filter into
channel at rear of hood. Push filter up while pushing tab back.
When filter is in place, release tab. Locking pin will hold filter
in place.
t,
2.
Check operation of the range hood by turning on the power.
The range hood controls are located in front on the underside
of the range hood.
A B
A. Controls
B. Filters
3. Move the light switch to "1" position. The light should turn on.
4. Move blower switch to "1" position. The blower should
operate.
5. Move the blower speed switch to "1" position for low speed,
"2" position for medium speed or "3" position for high speed.
6. Move blower and light switches to "0" position to turn blower
and light off.
7. If the range hood does not operate, check to see whether a
circuit breaker has tripped or a house fuse has blown.
Disconnect power supply and check that the wiring is correct.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.