Jenn-Air JGC8430CDS11 Use & Care Manual page 9

T
Surface burner fails to light.
* Check
* Check
* Check
* Check
* Check
to be sure plug is securely inserted into receptacle.
or re-set circuit breaker. Check or replace fuse.
power supply.
to be sure burner is correctly rated for your kind of gas.
to be sure burner ports or ignition ports are not clogged.
* Check to be sure ignitor is dry and clicking. Burner will not light if ignitor is damaged,
soiled or wet. If ignitor doesn't click, turn control knob OFF.
* Check to be sure burner cap is correctly seated on the burner base.
Surface burner flame lifts * Check to be sure a pan is sitting on the grate above.
off ports. • Contact an authorized Jenn-Air servicer.
The flame is uneven. * Burner ports may be clogged.
• Flame may need to be adjusted. Contact an authorized Jenn-Air servicer.
Surface burner flame is
yellow in color.
* Some yellow tips on the flame are acceptable when using LP gas.
* Contact an authorized Jenn-Air servicer.
8
9 8/8/06, 8:41 AM