Advertisement
Available languages
Available languages
TO REPLACE
DUST BIN UD
Replace
dust bin lid assembly by placing
b_ck on dust bin with marks on the lid
aligned as shown under Open (For
Emptying) on the back of the dust bin.
Turn This Direction
To Close For Use
Open
(For Emptying)
Closed
(For Use)
Rotate clockwise while pressing downward
so marks align as shown above C/osed
(For Use).
Insert dust bin
into cleaner.
Lowerthe dust
bin handle to
oust ale-
lock dust bin in Handle
place.
A noticeable
"click" should
be heard.
ElectricalShock Hazard
Unplug power cord from electricalout-
let. Do not operate the vacuum dean-
er withoutthe motorsafety filter. Be
sure the filter is dry and properly
Installed to preventmotorfailure and/or
electrical shock.
MOTOR SAFETY FILTER
Check motor safety filter frequently
and clean
when dirty.
J
J
J
,,,,<
i
Y
_Filter
Release
Handle
1. To remove motor safety filter lift filter
release handle upward and rotate the filter
cover out.
2. Remove filter by pressing on the sides of
the filter frame and pulling out at the same
time.
Filter -"!
__
Frame
--
Filter
Cover
Bottom
Tabs
3. Clean filter if necessary by placing it under
running water wait until dry before replacing.
4. When putting the filter back into the filter
cover, listen for the filter assembly to snap
into place.
Note: Push only on frame, not filter itself.
5. Replace cover by fitting bottom tabs into
slots and rotating into compartment.
Push
filter release handle down until you hear a
noticeable "click".
16
Advertisement
