Storing Hose & Tools; Powered Hand Tool; How To Reattach Tool Cover - Hoover SteamVac LS Owner's Manual

|ml_
ill ii |1
E
Slide rack down into place. Insert screw
at (E) and tighten with a Phillips screw-
driver.
Storing hose _x tools
Store hose on holder by first positioning
hose in front section of holder.
Then continue wrapping hose as shown
snapping end of hose connector into
holder.
m
Slide crevice tool
(F)
into holder.
Position stair/upholstery nozzle in holder
at base of cleaner and snap it into place
as shown at arrow.
Insert end of bare floor attachrrient into
holder and snap into clip as shown.
Powered
hand tool
The
powered hand tool is shipped in a
plastic bag for protection. Remove the
bag before using the tool by first open-
ing tool door.
m
To remove powered hand tool ((}), pull it
down _lnd outward.
To reposition the tool, reverse this proce-
dure.
To remove the scrub module* (m), grasp
it at the sides and pull it forward.
To reposition module, fit tabs in the stor-
age area into holes on back of module.
Push
module to snap it securely into
position.
*included with some models
How to
reattach tool
cover
The
tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
holes on sides of tool storage area.