Storing Hose And Tools; Spinscrub Hand Tool - Hoover SteamVac V2 User Manual

1-9
H
Rotate top of caddy toward cleaner
handle. Slide caddy down so notch (G)
on caddy rests in hook (H) on cleaner.
1-12
K
Press hose into opposite side of caddy.
Loop hose at bottom of cleaner and
press into top of hook (K).
1-15
Insert top of bare floor tool (available at
additional cost if not included with your
cleaner) through "loop" on caddy. Slide
tool down into place.
1-10
G
Identify the hose parts before storing
hose.
I. Nozzle connector end
J. Solution tube
1-13
Loop hose over top of caddy again.
Slide hose clip (L) toward end of hose.
Snap tab (M) on hose connector into
hose clip.
1-16
Snap stair/upholstery nozzle onto
caddy.
I
J
M
L
1-11
Storing hose and
tools
Press hose, a few inches from nozzle
connector end (I), into caddy. Bring
hose up and over top of caddy.
1-14
J
Repeat on other end of hose.
Press solution tube (J) into opposite side
of clip.
1-17
SpinScrub™ hand tool
(not included with all models)
The SpinScrub™ hand tool is shipped in
a plastic bag for protection. To remove
the bag before using the tool, open tool
door.
I
5