Assemble Handle; Attach Upper Handle; Attach Hose Holder; Attach Tool Holder - Hoover SteamVac LS Owner's Manual

The
assembled cleaner will look like this
drawing (hS model shown).
Assemble handle
Attach upper handle
Remove clean solution tank (upper tank)
from deep Gleaner.
m
A
I
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle.
Push bolts
into holes
on front of han-
dle.
If bolts will not go through hole easi-
ly handle is not pushed completely
down.
Attach
hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
Place nuts
in recessed areas on
back of
handle.
Hold each nut in place while
tightening each bolt securely (from the
front of the handle) with a Phillips screw
driver.
Only two nuts are needed on this model.
The
extra nut is not required but has
been provided for your convenience.
When handle sections are completely
together, squeeze trigger (C) and
depress Clean Surge TM Button
(D)
on
upper handle to snap trigger rod in
place.
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place.
Press cord into cord clip on back of
handle. Pull cord tight.
Attach tool holder
Remove tool and taped screw from holder.
Insert projections on holder into slots on
back of Gleaner.