Storing Hose And Tools - Hoover SteamVacTM V2TM Owner's Manual

1-9
Identify the hose parts before storing
hose.
G. Nozzle connector end
H. Solution tube
1 - 1 2
K
K
Loop hose over top of caddy again.
Slide hose clip (J) toward end of hose.
Clip loose hose to hose in caddy. Press
solution tube (K) into small clip on hose
clip (inset).
1 - 1 5
SpinScrub™ hand tool
(not included with all models)
The SpinScrub™ hand tool is shipped in
a plastic bag for protection. To remove
the bag before using the tool, open tool
door.
1-10
G
H
Storing hose and
tools
Press hose, a few inches from nozzle
connector end, into caddy. Bring hose
up and over top of caddy.
1 - 1 3
J
Insert top of bare floor tool (available at
additional cost if not included with your
cleaner) through "loop" on caddy. Slide
tool down into place.
1 - 1 6
Pull tool down and outward.
To reposition the tool, reverse this proce-
dure.
1 - 1 1
I
Press hose into opposite side of caddy.
Loop hose at bottom of cleaner and
press into top of hook (I).
1 - 1 4
Snap stair/upholstery nozzle onto
caddy.
1 - 1 7
How to reattach tool
cover
The tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
holes on sides of tool storage area.
Snap door into place.
5