Headlight Replacement; Belt Replacement; How To Replace - Hoover U5491-900 Owner's Manual

Hide thumbs Also See for U5491-900:
Table of Contents

Advertisement

Available languages

Available languages

Check agitator shield
Because your cleaner picks up so well, we
strongly
recommend
you check for debris
accumulation
under the agitator shield each
time you clean the filters.
Removing
debris under the shield will help
maintain
your cleaner's excellent
pick up
and suction.
Remove debris as follows:
1. Disconnect
cleaner from electrical
outlet.
2. Check for dirt accumulation
by removing
bottom
plate (Pig. 3-10), removing
agitator
(Fig. 3-I1), and ]ifting agitator
shield (Fig.
3-13).
3. Remove any debris and replace shield,
agitator
and bottom
plate [Figs. 3-13 to
3-15).
Headlight replacement
(some models only}
What to buy
This cleaner uses a 12 volt, wedge base type
912 bulb, Hoover part No. 27313101.
Removing lens
Disconnectcleaner
from electrical
outlet.
Using a screwdriver,
remove the two
screws
as shown
and lift off lens.
Installing bulb
PuN old bulb
straight out of
socket. Push new
bulb straight
into
socket until locked
in place.
Excessiveforce is
not required.
Replacing lens
Reposition
lens and
secure with the two
screws.
Belt replacement
The belt on your Hoover cleaner causes the
agitator
to rotate and is important
for the
effective
operation
of the cleaner. The belt
is located
under the bottom
plate of the
cleaner and should be checked from time to
time to be sure it is in good condition.
When to replace
Disconnect cleaner from electrical outlet.
To check belt, remove bottom
plate as shown
in "How to replace". Replace belt if it is
stretched,
cut or broken.
What to buy
To assure effective
operation, use only gen-
uine HOOVER belts with your cleaner.
When
purchasing
a new belt, ask for HOOVER part
No. 38528033.
How to replace
Disconnect cleaner
from electrical
outlet.
Removing
bottom plate
Place handle in low
position
and turn
cleaner over so bot-
tom side is up.
A
Remove the 4
screws as shown with a Phillips screw driver.
Lift off bottom
plate (A).
Removing belt
Remove agitator
brush roll and used
belt.
Discard used belt.
12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

U6485-900

Table of Contents