Kenmore 362.6112 Series Use & Care Manual page 40

PROBLEM POSSIBLE CAUSE
TOPBURNERS DO NOT
LIGHT OR DO NOT
BURN EVENLY
BURNER FLAMES VERY
LARGE OR YELLOW
=
SURFACE BURNERS
LIGHT BUT OVEN
DOES NOT
• Make sure electrical plug is plugged into a live power outlet.
° Burner holes on the side or around the top of burner may be clogged. Remove
burners (on models with standard twin burners) or burner heads (on models
with sealed burners) or burner caps on spill-proof models, and clean them
with a sewing needle or bare wire Make sure you do not enlarge the burner
holes. On spiIFproof models, check electrode area for burned-on food or grease..
• Make sure the drip pans (on some models) are installed correctly .....
- Pilot(s) is (are) not lit (on standing pilot models)° See the Lighting Instructions
for Standing Pilot Models section in Surface Cooking,.
• If range is connected to LP gas, contact the person who installed your range
or made the conversion.
The oven gas shut-off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut-off valve on standard twin burner models, raise the
cooktop and look for the gas shut-off lever at the extreme right rear corner.
Follow the directions in box A or B that match your regulator type.
Lever shown closed/
Standard Twin Burner Models
Lever shown closed /
Standard Twin Burner Models
To check the oven gas shut-off valve on sealed burner models, remove
the broiler drawer and look for the gas shut-off lever at the back of the range.
. )
Lever shown /
\ closed. PULL /
Sealed Burner Models
4O