Solutions To Common Problems; Common Drying Problems - Electrolux IQ-Touch EIMGD60LT0 Use & Care Manual

Solutions to Common Problems
Common D ing Problems
PROBLEM
Greasy, oily
stains
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and
scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The
Soap and Deter(_ent Association.
POSSIBLE CAUSES PREVENTIVE MEASURES
• Fabric softener sheet.
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
Wrinkling
SOLUTIONS
Rub fabric softener stains
with bar soap. Rinse and
rewash.
Overloading.
Overdrying causes static
electricity.
Lint screen not clean when
cycle began.
Lint is attached to "pills."
Overdrying.
Temperature too high.
• Overdrying.
Overloading.
Leaving items in dryer after
cycle ends.
Reduce load size and
rewash using liquid fabric
softener in the final rinse.
Or, add a fabric softener
sheet and tumble without
heat.
Use lint brush or roller to
remove lint.
Use a lint brush or shaver to
remove pills.
Irreversible condition.
Reduce load size and
tumble at medium or low
heat for 5-10 minutes.
Add a few bath towels
to small loads for proper
tumbling.
Some "silk-like" fabrics
should be air dried.
Use proper drying tempera-
ture.
Place fabric softener sheet
on top of load before start-
ing the dryer.
Do not overload dryer.
Use fabric softener in
washer or dryer to reduce
static electricity.
Remove items when they
are slightly damp to avoid
overdrying.
Check that lint filter is clean
and in place.
Use fabric softener to lubri-
cate fibers.
When ironing, use spray
starch or fabric finish on
collars and cuffs.
Turn items inside out to
reduce abrasion.
o
o
o
Remove items immediately.
Hang or fold.
o
o
o
Follow fabric care label
directions.
If shrinking is a concern,
check load often.
Remove items while slightly
damp and hang or lay flat to
complete drying.
Block knits into shape.
Do not overload dryer.
Remove items as soon as
cycle ends.
Isolated wet • Low water line pressure in • Check water line pressure • Ensure water line pressure
spots on fabrics home is not sufficient to is minimum of 30 psi. Do
after completed atomize incoming water not exceed 120 psi.
Steam cycle during Steam cycle