Download Print this page

Solutions To Common Problems; Common Drying Problems - Electrolux IQ-Touch EIED50LIW0 Use & Care Manual

Iq-touch front-load gas & electric dryer
Hide thumbs

Advertisement

Solutions
to Common
Problems
Common
Drying Probmems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and
scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The
Soap and Detergent Association.
PROBLEM
Greasy, oily
stains
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
Wrinkling
Isolated wet
spots on fabrics
after completed
Steam cycle
POSSIBLE CAUSES
SOLUTIONS
PREVENTIVE MEASURES
• Fabric softener sheet.
• Rub fabric softener stains
with bar soap. Rinse and
rewash.
Overloading.
Overdrying causes static
electricity.
Lint screen not clean when
cycle began.
Lint is attached to "pills."
Overdrying.
Temperature too high.
Overdrying.
Overloading.
Leaving items in dryer after
cycle ends.
Low water line pressure in
home is not sufficient to
atomize incoming water
during Steam cycle
Reduce load size and
rewash using liquid fabric
softener in the final rinse.
Or, add a fabric softener
sheet and tumble without
heat.
Use lint brush or roller to
remove lint.
Use a lint brush or shaver to
remove pills.
Irreversible condition.
Reduce load size and
tumble at medium or low
heat for 5-10 minutes.
Remove items immediately.
Hang or fold.
Check water line pressure
Add a few bath towels
to small loads for proper
tumbling.
Some "silk-like" fabrics
should be air dried.
Use proper drying tempera-
ture.
Place fabric softener sheet
on top of load before start-
ing the dryer.
Do not overload dryer.
Use fabric softener in
washer or dryer to reduce
static electricity.
Remove items when they
are slightly damp to avoid
overdrying.
Check that lint filter is clean
and in place.
Use fabric softener to lubri-
cate fibers.
When ironing, use spray
starch or fabric finish on
collars and cuffs.
Turn items inside out to
reduce abrasion.
Follow fabric care label
directions.
If shrinking is a concern,
check load often.
Remove items while slightly
damp and hang or lay flat to
complete drying.
Block knits into shape.
Do not overload dryer.
Remove items as soon as
cycle ends.
Ensure water line pressure
is minimum of 30 psi. Do
not exceed 120 psi.

Advertisement

loading

  Also See for Electrolux IQ-Touch EIED50LIW0

  Related Manuals for Electrolux IQ-Touch EIED50LIW0

This manual is also suitable for:

Iq-touch eigd50liw0Iq-touch eimgd55iiw4