Solutions To Common Problems - Electrolux EIED55IKG - 8.0 cu. Ft. Electric Dryer Use And Care Manual

Solutions to Common Problems
Common D ing Probmems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and
scum, and fabric damage. For satisfactory drying results, follow these suggestions provided by The
Soap and Detergent Association.
PROBLEM POSSIBLE CAUSES SOLUTIONS
Greasy, oily • Fabric softener sheet. • Rub fabric softener stains
stains
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
with bar soap. Rinse and
rewash.
• Overloading.
Overdrying causes static
electricity.
Lint screen not clean when
cycle began.
Lint is attached to "pills."
Overdrying.
Temperature too high.
Overdrying.
Reduce load size and
rewash using liquid fabric
softener in the final rinse.
Or, add a fabric softener
sheet and tumble without
heat.
Use lint brush or roller to
remove lint.
Use a lint brush or shaver to
remove pills.
Irreversible condition.
PREVENTIVE MEASURES
Add a few bath towels
to small loads for proper
tumbling.
Some "silk-like" fabrics
should be air dried.
Use proper drying tempera-
ture.
Place fabric softener sheet
on top of load before start-
ing the dryer.
Do not overload dryer.
Use fabric softener in
washer or dryer to reduce
static electricity.
Remove items when they
are slightly damp to avoid
overdrying.
Check that lint filter is clean
and in place.
Use fabric softener to lubri-
cate fibers.
When ironing, use spray
starch or fabric finish on
collars and cuffs.
Turn items inside out to
reduce abrasion.
Follow fabric care label
directions.
If shrinking is a concern,
check load often.
Remove items while slightly
damp and hang or lay flat to
complete drying.
Block knits into shape.
Wrinkling • Overloading. • Reduce load size and • Do not overload dryer.
Leaving items in dryer after tumble at medium or low • Remove items as soon as
cycle ends. heat for 5-10 minutes, cycle ends.
Remove items immediately.
Hang or fold.