Download Table of Contents Print this page

Operating Your Dryer - Electrolux IQ-Touch EIMGD60LT0 Use & Care Manual

Front-load gas & electric dryer
Hide thumbs Also See for IQ-Touch EIMGD60LT0:


Table of Contents
YOUR DRYER, continued
o Place delicate or small items in a mesh bag.
Be sure buckles,
buttons and trim
are heatproof and
won't damage
the drum finish.
Close zippers;
fasten hooks and
VelcroQlike fas-
teners. Tie strings
(Mesh bag not included.)
and sashes to prevent snagging and tangling.
2. Check
that the lint filter
is clean and
in place.
3. Load the
dryer and
the door.
Load items loosely. The average wet load will
fill the drum 1/3 to 1/2 full. Items need room to
tumble freely for even drying and less wrinkling.
If desired, place a dryer fabric softener sheet on
top of the load at the beginning of the cycle.
To save energy and time and avoid uneven
drying and wrinkling, do not overload the
When drying large items, dry only two or three
items at a time. Fill out the load with small and
medium sized items.
For delicate or very small loads, add two or
three similar items to improve tumbling action.
4. Select
the appropriate
cycle and
for each load.
• Turn the cycle selector knob in either direction
to select the cycle desired. The estimated dry-
ing time for Auto Dry cycles or the actual drying
time for Time Dry cycles will be displayed.
A suitable drying temperature, dryness level
and options will automatically be indicated for
the cycle selected. See the "Dryer Settings
Chart" for more details.
To change the drying temperature and dryness
level, press the temperature and dryness but-
tons to scroll to the desired settings.
To select or delete an option, press the button
for that option. The indicator will be illuminated
when the option has been selected. The indica-
tor will no longer be lighted when the option has
been deleted.
Adjustments made to a cycle will be remem-
bered and recalled each time that cycle is
selected in the future.
press these two buttons at
the same time and hold until
the signal sounds.
5. Start the cycle.
Close the door and press start to begin the
cycle. The dryer will not operate with the door
open. To interrupt the cycle, press pause;
press start to resume the cycle. Press cancel
to stop the cycle.
If changes to the cycle, temperature, dryness
level or options are attempted after the cycle
starts, the lights will blink and a signal will beep.
To change the cycle once the cycle has be-
gun, press cancel and select a new cycle. To
change the temperature, dryness level or op-
tions once the cycle has begun, press pause
and make the new selections.
A signal will sound at the end of the cycle if
the chime option has been selected. When the
cycle ends, remove the items promptly and
hang or fold.


Table of Contents

Table of Contents