Exmark Lawn Tractor Operator's Manual page 41

Exmark mfg. co. inc. lawn tractor operator's manual
Table of Contents

Advertisement

b) Measure the length of the spring. Measurement should be 2.75" (7.0 cm)
between washers (see Figure 14).
c) If adjustment is necessary, tighten the nut directly below the yoke and
loosen the bottom nut (bottom one of the two tightened together) below the
spring. Turn the nut directly below the washer (top nut of the two tightened
together) until the correct measurement is obtained. Tighten the two nuts
together and repeat on opposite side of unit. Turn clockwise to shorten
spring length and turn counter-clockwise to lengthen the spring.
3/16" (4.8 mm) to
1/4" (6.4 mm)
5.2.9
Brake Adjustment.
a) Check for brake link 2.75" (7.0 cm) measurement as described in section 5.2.8.
b) Engage brake lever (lever up).
c) Measure the distance between the trunion roller and the rod collar.
Measurement should be 3/16" (4.8 mm) to 1/4" (6.4 mm). See Figure 14.
d) If adjustment is necessary, loosen the nut directly below the yoke. Turn the
bottom nut (below washer) until the correct measurement is obtained (See
Figure 14) turn nut clockwise to lengthen the gap (screws rod into yoke) and
turn counter-clockwise to shorten the gap (screws rod out of yoke). Tighten
nut against yoke and check opposite side of unit, repeat if necessary.
5.2.10
Adjust Throttle Lever Tension.
a)
Stop engine, wait for all moving parts to stop, and remove key.
b)
Tension in throttle lever can be adjusted by adjusting the tightness of the
lever pivot bolt, which is located under the console (See Figure 15).
5.2.11
Electric Clutch Adjustment:
No adjustment necessary.
5.2.12
Reverse Indicator Adjustment:
a)
Stop engine, wait for all moving parts to stop, and remove key.
b)
Unhook seat latch and tilt seat forward.
c)
Begin with either the left or right motion control lever. Move lever to the
neutral position and pull lever back until the clevis pin (on arm below pivot
shaft) contacts the end of the slot (just beginning to put pressure on spring),
See Figure 16.
FIGURE 14
BRAKE ADJUSTMENT
FIGURE 15
THROTTLE TENSION
- 36 -
2.75"
(7.0 cm)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lazer z advantage series

Table of Contents