Kenmore 363.58892890 Owner's Manual page 23

Side by side 24, 28 and 30 models
Table of Contents

Advertisement

Available languages

Available languages

Light
BuOb Replacement
Unplug
refrigerator
before
changing
a
Hght bulb.
Before
replacing
a burned-out
light
bulb,
unplug
the refrigerator or turn
off power at the circuit
breaker
or fuse box in order to avoid contact
with a live wire
filament.
(A burned-out
light bulb may break when
being replaced,)
Note:
Moving
the control
to the
OFF
position
does not remove power to the light
circuit.
Fresh
Food
Compartment--Upper
Light
I. To align the contro!
knobs
properly,
note the position
of each Imob for proper
reassembly,
move both Imobs
all the way to the left, then
pull them
off:
Pin
2. To remove
the light shield,
pull it straight
out.
After replacing
with an appliance
bulb of the same or
lower wattage,
reinstall
the light shield. Replace
the
control
lmobs,
move them to their previous
settings
and plug the refrigerator
back in
Fresh Food Compartment--Lower
Light:
(on some models)
This light is located behind the top drawer or right
above the top drawer (depending
on your model).
I. Unplug the refiigetator.
2. If the light is behind the top drawer you will need
to remove the drawer and the shelf above it, To
remove the drawer see To Remove Stmage Drawers
in the Shelves and Storage Drawers section,
To remove the shelf; first
remove any food on the
shelf: Then tilt the shelf up
at the front and lift it up
and out of the tracks
3J
Grasp the bottom
of
the light shield and pull it
forward
and up_
4. After replacing with same size bulb, replace the
o
shield,
if you cannot
locate
the correct
bulb, see
your: dealer.
If the light was behind
the top dzawer; you will need
to replace the drawer
and the shelf above it.
To replace the shelf, raise the shelf front slightly and
engage the top hooks in the lowest large track slots.
Then lower the front of the shelf until it is level.
6. Plug the reffigeiator back in.
Freezer
Compartment
I. Remove shelf just below
light panel. (Shelf will be
easier to remove if it is
emptied first.)
2. Puli plastic light panel
toward you. (It will bend
to flee tabs from grooves°)
3, After replacing with same
size bulb, reinstall pariel and shelf.
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

36358897890

Table of Contents