Advertisement
REMOVABLE
KNOBS
MOLDED
RiB
SPRfNG
CLIP
Electrical
power
must be shut off if you have to
replace
a broken
bulb.
1,
Unscrew glass cover and remove.
2_ Replace the bulb with a 40 watt appliance bulbo
3_ Replace the covero
Note:
We recommend you use a 40 watt appliance bulb
that is no longer than 3 t/2".
All control knobs may be removed for easy cleaning by
pulling the knob straight off the stem° Be sure that the
knob is in the OFF position before removal
Hint: Slip a thin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull Upo
Caution:
Read these Instructions
carefully before
replacing the knobs. Replacing the knobs improperly
will damage the knobs and the spring clips on the
stems. If this happens, the knobs will fit Ioosely_
To replace the knob:
1. The knob stem has a groove in each side_ The
groove on one side has a spring clip. The other
groove is clear (see illustration).
2.
Check the Inside of the knob and find the molded rib
3.
Replace the knob by fitting the molded rib inside the
knob into the clear groove on the stem.
Note:
Be sure to replace
knobs on the correct
stems.
REPLACING
THE OVEH
LIGHT
GLASS
RETAINER
GLASS_
COVER
LIFT=UP
COOKTOP
SUPPORT RODS
The cooktop can be raised so the area underneath
can
be cleaned_
Raise the front of the cooktop until the support rods
snap into position to hold the cooktopo
To lower cooktop, push in on the front of the supports
while lowering
top
Porcelain
enamel
can chip if dropped.
Handle
porcelain
enameled
cooktops
carefully.
Be sure that the light switch
is in the off position.
Do not touch hot oven bulb,
Do not touch
oven
bulb with wet hands. Do not wipe even light area
with wet cloth,
Never
touch
the electrically
llve collar
on the
bulb when replacing
it,
19
NEMNT101
Advertisement
