Adjust The Stitch - Kenmore 19502 Owner's Manual

Buttonholes [] -_ [] (Continued)
• Adjust the Stitch Density
You can adiust the stitch density of the entire
buttonhole or of only one side.
The stitch length button controls the stitch
density. It is pre-set at "O,4".
Set the Machine
/9 2// 21
Fine Coarse
stitches stitci)es
Stitch Density in Entire Buttonhole:
Press "+'" or "-" to adjust the stitch density of
the entire buttonhole.
68
Stitch Density on One Side:
The stitches on each side of the buttonhole should
be the same stitch density. To adjust, use the feed
balance dial below the Hand Wheel.
A
For Condition A:
Left Side Stitches too Far Apart
(see above)
Turn the feed balance dial slightly
toward "'-'" Use the large screw
driver in your accessory box.
Feed
_balance
B
For Condition B:
Right Side Stitches too Far Apart
(see above)
Turn the feed balance dial slightly
toward "+".
After adjusting the feed balance dial, sew another test buttonhole to be sure
your adjustment is correct.
NOTE: Remember to turn the feed balance dial to the standard mark
( 1_ ) when you have completed your buttonholes.