Additional Spool Pin - Kenmore 19502 Owner's Manual

Prepare the Bobbin
• Put Thread on the Spool
Ordinary spool
Large
spool [_-/'_ SPr_°l
holder _/JF//X_ P
Small spool
Small Spool
spool pin
holder
NOTE:
Your spool pin tilts upward for
ease in putting thread on the
spool.
You have two spool holders:
large (under the top cover)
(in your accessory box).
1.
and small
Choose the appropriate spool holder.
2. PEace your thread on the spool pin and
then fit the spool holder down over it,
so that the thread winds toward the
back of the machine, as shown.
3. Press the spool holder against the spool.
4. Lower the spool into the well.
= Additional Spool Pin
NOTE:
/Spooi pir
_ r--<" fe ,
__. _/Addidonal
_I"_ spool pin
Spool_
hole
For winding the bobbin while your machine is threaded, you have an extra
spool pin in your accessory box. It fits into the square hole on top of
your machine near the bobbin winder.
To Use This Extra Spool Pin:
1. Fit the square end of the spool pin into the square hole, as shown.
2. Fit the spool pin felt on the base of the spool pin.
3. Put your spool of thread on top of the felt, with the thread winding in the
direction shown. See directions for winding the bobbin, p. lg _20.
18