Thread Your Needle - Kenmore 19502 Owner's Manual

Prepare Your Top Thread (Continued)
• Thread Your Needle
NOTE: The numbered steps below follow the numbers on the illustrations.
NOTE: Dotted lines show places where the thread loops and then is pulled tight. Each place has a spring.
-@
Hold the thread, as shown. Press the thread
down until it clicks and comes down under the
hook in the top cover thread guide.
2. Draw the thread around the thread guide and 6.
down into the tension area.
3. Pu}l the thread up from left to right around the 7.
check spring wire.
4. Draw the thread straight up and from left to 8.
right through the slot and into the eye of the
take-up lever.
5.
\ J
Draw the thread down and slip it through the
right side of the right-hand thread guide, as
shown,
Pull the thread to the left and slip it through
the left thread guide,
Slide the thread through the needle bar guide
on the left.
Thread the needle from front to back.
NOTE: You may want to cut the end of the
thread with sharp scissors for easier
needle threading.
24