Advertisement
Available languages
Available languages
CHECK
FOR VERTICAL
ALIGNMENT
1.
The vertical alignment is set correctly when the lines
do not move horizontally
(sideways)
as the saw
head is raised and lowered. If vertical alignment is
correct jump to "TO SET LEFT AND RIGHT KERF
ADJUSTMENT".
2.
If the vertical alignment needs to be adjusted, begin
by backing the left and right kerf adjustment screws
one half turn clockwise. Remove the laser unit cover
by removing the phillips screw on either side of the
cover. (Fig. A).
3.
Use the 1/8" hex wrench to turn the left or right
vertical alignment set screws.
If as the saw head
goes from a raised to a lowered position and the laser
line moves horizontally
away from the blade, turn
vertical alignment set screw clockwise to correct. If
the laser line moves horizontally towards the blade,
turn vertical alignment set screw counter-clockwise
to correct. (Fig. F)
4.
Reinstall cover removed in step 1, and continue to "TO
SET LEFT AND RIGHT KERF ADJUSTMENT".
TO SET LEFT and RIGHT KERF
ADJUSTMENT
1.
Use the 1/8" hex wrench to turn the left or right kerf
adjustment screws and set the laser lines to either
side of the test cut (Fig. G). To adjust the left line turn
the left kerf adjustment
screw counter-clockwise
to move the line toward the blade and clockwise
to move the line away from the blade.
To adjust
the right line turn the right kerf adjustment
screw
counter-clockwise
to move the line toward the blade
and CW to move the line away from the blade. (Fig.
H)
_
Observe laser label (L) Fig. H.
2.
Remove the padlock and use normally.
TwinLaser
TM
MAINTENANCE
For best
laser
performance,
perform
the following
maintenance regularly:
1.
_
DISCONNECT
MACHINE
FROM
m
POWER SOURCE.
2.
Carefully clean sawdust from each laser lens with a
cotton swab Fig. J. Do not use solvents of any kind
since they may damage the lens. Avoid touching
sharp points of saw blade with your hands or fingers.
Dust build-up can block the laser and prevent it from
accurately indicating the line of cut.
3.
Remove blade from saw and clean pitch build-up
from blade Fig. K Pitch build-up can block the laser
and prevent it from accurately indicating the line of
cut.
Fig. F
WRONG
RIGHT
Fig. G
Fig. H
Fig, J
Fig. K
15
Advertisement
