Maintenance; Keep Machine Clean; Maintenance Reminders - Delta 36-6013 Manual

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before
installing and removing accessories, before adjusting and when making repairs. An accidental start-up can cause injury.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth. NEVER use
solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
For best performance use a shop vacuum or blower to KEEP saw blade area, the dust collection system, the guarding system and rails
free of saw dust and other debris.

MAINTENANCE REMINDERS

Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
ALWAYS turn saw off and unplug from power source before making adjustments or performing maintenance.
Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE: KEEP this area free of dust and debris buildup. Blow out area regularly with compressed air.
NOTE: If the riving knife clamp can't move freely, have the saw serviced by authorized DELTA
BEVEL GEARS: KEEP the bevel gears free of dust and debris buildup. Blow out area regularly with compressed air. Use a lithium-
based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY: NOTE: Debris can also be removed from the saw from below the
throat plate, inside the dust port.

MAINTENANCE

37
service center personnel.
®