Advertisement
Available languages
Available languages
FOR
YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY
ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION
MANUAL.
ASSEMBLY
TOOLS REQUIRED
Wrench (Supplied)
2mm Hex Wrench (Supplied)
Open-end 7/16" Wrench (Supplied)
ASSEMBLY
TIME ESTIMATE
Assembly for this machine takes less than 30 minutes.
ATTACHING
THE
DUST
BAG
1.
Attach the dust spout (A) Fig. 3 to the dust port (B).
2.
Depress the spring clips (C) Fig. 3 of dust bag (D) and clip the dust bag (D) over the rib of the dust spout (A).
MOVING THE CUTTINGHEAD
TO THE UP POSITION
Push down on the handle (B) Fig. 4. Pull out the cutting-head
Iockpin (A) and move the cuttinghead to the up position.
NOTE: The tension of the cuttinghead
return spring has been adjusted at the factory so that the cuttinghead
returns to the "up"
position after a cut has been made. If the head fails to return properly, please take the tool to your nearest authorized
service
center for service.
MOVING
THE TABLE TO THE 0 ° CUT-OFF
POSITION
1.
Rotate the locking knob (A) Fig. 5 counter-clockwise
as far as it will go. Depress the lever (B) and rotate the table
(C) to the 0° straight cut-off position, release the lever (B), and tighten the locking knob (A).
NOTE: This saw incorporates a new slotted plate design feature (D) Fig. 6 with location adjustment screws (E) for
fine-adjusting
the cutting angle.
2.
For proper operation and adjustment of the table, refer to sections, "ROTATING TABLE FOR MITER CUTTING",
and "ADJUSTING
SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.
[ Fig. 5 ]
Fig. 6
9
Advertisement
