Advertisement
Available languages
Available languages
FENCE
OPERATION
DISCONNECT
MACHINE FROM POWER SOURCE.
The saw is equipped with two fences. The fence that is
shipped bolted to the table should remain and needs no
adjusting. The other fence piece (A) Fig. 7 is adjustable
and should be placed as close to the blade as possible
for all bevel or straight cuts to provide adequate support
and for an accurate cut.
To adjust,
place fence
piece
(A)into
guide
groove
(B) and move it to the desired location. Insert knob (C)
to lock in place.
NOTE: The gu ide groove of the fen ce can become clogged
with sawdust. Be sure to clean it out periodically.
[]
[]
MAKE SURE THAT THE FENCE IS CLEAR OF THE GUARD AND BLADE BEFORE OPERATING
THE SAW.
FASTENING
THE MACHINE
TO A SUPPORTING
SURFACE
Before operating your compound miter saw, firmly mount
it to a workbench or other supporting surface. Four holes
(two of which are shown at (A) Fig. 8) are provided for
fastening the saw to a supporting surface.
When frequently
moving the saw from place to place,
mount the saw to a 3/4" piece of plywood.
The saw
can then be easily moved from place to place and the
plywood
can be clamped
to the supporting
surface
using "C" clamps.
[OPERATIONAL
CONTROLS
AND ADJUSTMENTS
[
STARTING
AND STOPPING
THE MACHINE
To start the machine, depress switch trigger (A) Fig. 9. To
stop the machine, release the switch trigger.
This saw is equipped with an automatic electric blade
brake. As soon as the switch trigger (A) Fig. 9 is released,
the electric brake is activated and stops the blade.
A turning saw blade can be dangerous. After completing the cut, release the switch trigger (A) Fig.
9 to activate blade brake. Keep cuttinghead down until the blade has come to a complete stop.
The torque developed during braking may loosen the arbor screw. The arbor screw should be
checked periodically and tightened if necessary.
LOCKING
THE SWITCH
IN THE "OFF"
POSITION
IMPORTANT: When the machine is not in use, the switch should be locked in the "OFF" position to prevent unauthorized
use, using a padlock (B) Fig. 10 with a 3/16" diameter shackle.
In the event of a power outage, always
lock switch
in "OFF" position until the main power
is restored.
10
Advertisement
