First
Steps
3" AIR SPACE
Clearance
Proper air circulation
and leveling will
ensure efficient operation
/
/,¢
J-'_-'_,i
, /
%,
_._
RAISE
LOWER
Sc_ewotype Levelers (somemodels)
LOWER
CABINET
CABINET
Exposed bolt (some models)
LOWER
CABINET
CABINET
Sunken bolt (some models)
Before
starting
the refrigerator,
follow
these important
first
steps:
Location
o
Choose a place that is near a grounded electrical outlet
DO NOT use an
extension cord or an adapter plug
,
If possible, place the refrigerator out of direct sunlight and away from the
range, dishwasher or other heat sources
o
Tile refrigerator must be installed on a floor that is level and strong enough
to support a fully loaded refrigerator
o
Consider water supply availability for models equipped with an automatic
ice maker
Installation
o
Do not install the refrigerator where the temperature will drop below 60%
(! 5°C) or rise above 110% (43°C) The compressor will not be able to maintain
proper temperatures
•
Allow space around the unit for good air circulation Leave a 1 inch (25 ram)
space behind and a 3 inch (75 ram) space above the refrigerator for adequate
circulation
o
tn a recessed installation, allow an extra t/2 inch (t0-15 ram) on each side
for ease of installation
°
For best circulation, elevate the unit 1 inch (25 mm) from the floor, especially
if the floor is carpeted,
Door
Opening
The doors should open to allow easy access to a counter when removing food
• Do not position the refrigerator so you have to walk around the refrigerator
doors
Reversethe doors if necessary See "Reversible Door Instructions "
Leveling
All four corners of refrigerator must rest firmly on a solid floor
Some models are
equipped with adjustable screwotype Ievelers Others are equipped with rollers If
you refrigerator did not come with rollers, they can be purchased from you dealer
•
To adjust screw-type
levelers (some models): Tip the cabinet back slightly,
and raise the adjusting bolts as needed
o
To adjust front
rollers (some models):
Use a screwdriver, 3/8" socket
wrench, or nutdriver to adjust the roilers as shown
RAISETHE FRONTof the cabinet enough so doors will close freely when opened
halfway
Level the cabinet side to side
Cleaning
°
Wash the inside, all removable parts and the outside with mild detergent and
warm water Wipe dry DO NOT USE HARSH CLEANERS ON THESE
SURFACES,
•
Do not use razor blades or other sharp instruments which can scratch the
appliance surface, when removing adhesive tabels Any gtue left from the
_ape or energy label can be removed wittq a mixture of warm water and mild
detergent, or touch the residue with the sticky side of tape already removed
•
DO NOT REMOVETHE SERIALPLATE
Need help?
Do you have a question about the 2539368010 and is the answer not in the manual?