Table of Contents
Advertisement
Step 7
Exhaust Information
For Outside
Vented
Models Only
1. Adjustable
Exhaust
Outlet
Hood exhaust outlet is adjustable to compensate for
duct-work misalignment.
In the top (vertical) exhaust
position, it can be adjusted 7/3"Z' to the left or right of
center, and it has a total adjustment
of 7/16" from front
to rear of the range, in the rear(horizontal) exhaust posi-
tion, it can be adjusted 7/3,_' to the left or right of center,
and it has a total adjustment of 7/16" from top to bot-
tom of the range.
REMOVE 2 SCREWS
FOR FULL
ADJUSTMENT
TO REAR
HINGE
2. Top (Vertical)
Hood Exhaust
• Your range is shipped assembled for Top (Vertical)
Hood Exhaust. For installation under a close fitting
cabinet, the exhaust outlet assembly must be removed
from the top of the blower cover by removing 2 screws
and 2 plates. Insert the exhaust outlet assembly
into
the vertical exhaust pipe with the hinge of the damper
toward the wall. Temporarily secure with duct tape or
some other means. After range is in place, reassem-
ble exhaust outlet assembly to the top of the blower
cover with 2 plates and 2 screws.
* If there is space between the bottom of the cabinet
to clear the exhaust outlet assembly, it can remain in
place and be adjusted to fit with the vertical pipe by
loosening 2 screws.
3, Hood Exhaust
Conversions
(Optional)
Be sure the range is not connected
to the power.
Remove the 2 screws and damper assembly
from the
top of the hood. Remove the 11 screws and cover from
the hood. Lift the blower assembly out of the hood.
_
DAMPER ASSEMBLY
VENTED
A. Recirculating
Hood Conversion
Rotate the blower 90 degrees
FORWARD
(exhaust
toward front). Reassemble
the cover onto blower with
3 screws. Slide the blower-cover back into the hood.
Assemble the remaining
8 screws.
RECIRCU_'_LATING_OVER
A recirculating filter kit (Pub. No. 03-FOK6-01)is required
and must be installed intothe front of the hood.
B. Rear Exhaust
Conversion
Remove the wires from the 2 slotsand turn the blower
END to END. Then rotate the blower exhaust intothe
rear position. The wires can be unplugged for easier
realignment of blower.
j_:
._,,__AMPER ASSEMBLY
COVER
Reposition the wires into the slots (opposite side of
blower).Reassemble coveronto rear ofthe blowerwith
3 screws.Slide blower-cover back intohood. Reassem-
ble the remaining 8 screws. Locate and assemble the
damper assembly onto the rear exhaust of the hood
(cover) as shown.
Advertisement
Table of Contents
