Installation Instructions; Electrical Requirements; Preparation Of Wall Or Cabinet - Sears Kenmore Classic 98591 Owner's Manual

Table of Contents

Advertisement

INSTALLATION INSTRUCTIONS
Before you begin--Read
these instructions
com-
pletely
and carefully,
IMPORTANT--Save
these
instructions
for local
inspector's
use.
IMPORTANT--OBSERVE
ALL GOVERNING
CODES
AND ORDINANCES.
Note to Installer--Be
sure to leave these
instruc.
tions with the Consumer.
Note to Consumer--Keep this Owner's Manual for
future reference.
Note--This
appliance
must be properly grounded.
Tools You Will Need
Electric drill
3/32" drill bit
Phillips head screwdriver
Blade type screwdriver
Hammer
Knife
Electrician
pliers
Electrical Requirements
CAUTION, FOR PERSONAL SAFETY: DO NOT USE
AN EXTENSION CORD WiTH THIS APPLIANCE.
IMPROPER CONNECTION OF ALUMINUM HOUSE
WIRING TO COPPER LEADS CAN RESULT IN A
SERIOUS PROBLEM. USE ONLY CONNECTORS
DESIGNED FOR JOINING COPPER TO ALUMINUM
AND FOLLOW THE MANUFACTURER'S RECOM-
MENDED PROCEDURE CLOSELY.
REMOVE
HOUSE
FUSE
OR
OPEN
CIRCUIT
BREAKER
BEFORE
BEGINNING
INSTALLATION.
• This appliance must be supplied with the proper
voltageand frequency, and connectedto an individual,
properly grounded branch circuit, protected by a cir-
cuit breaker or time delay fuse, as noted on the rating
plate. (Rating plate is located on the lower oven door
frame.)
• Wiring must conform to National Electric Codes.
• If the electric supply provided does not meet the
above specifications, call a licensed electrician.
• Because range terminals are not accessible after
range is in position, flexible service conduit or cord
must be used.
Step I
Preparation of Wag or Cabinet
1. All vertical dimensions given are for 36" recom-
mended height fromtop of trim to floor. The leveling
screws can be used to obtain approximately 112'
additional height, but the vertical dimensions should
be adjusted accordingly.
2. Leveling screws must be reassembled to the range
after removing the wood shipping frame.
To eliminate the risk of burns or fire by reaching over
heated surface units, the maximum depth of cabinet
installed over range must not exceed dimensions as
shown in Fig. below.
15" V ENTED
MAX,
CAB.
DEPTH
WALL-
OUTLET
8OX
OUTLET 8 0X
INSTALLED
f OF RANGE
LEFT OF
OFRANGE
CORD
FLOOR
2-1/4"
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kenmore classic 98598

Table of Contents