Secondary Filter; Dust Bin Cleaning - Kenmore 11632729 Owner's Manual

TO REPLACE DUST BIN
Turn This Direction Open
To Close For Use (For Emptying)
Closed
(For Use)
Replace dust bin lid assembly by placing
back on dust bin with the marks on the lid
aligned as shown under Open (For
Emptying) on the back of the dust bin°
Rotate lid clockwise while pressing down-
ward so marks align as shown above Close
(For Use) as above°
Place dust bin
back into vacuum
cleaner by insert-
ing the bottom first
and tilt back with
the dust bin han-
dle raised.
Handle
Dust
Bin *-
Lower the dust
bin handle to lock
dust bin in place,
Check secondary filter frequently and clean
when dirty°
WARNING
Electrical Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is properly installed to prevent
motor failure and/or electrical
shock.
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
SECONDARY FILTER
FOAM
Remove the dust bin as outlined in the
DUST BIN CLEANING section,,
Remove secondary filter from vacuum
cleaner,.
Secondar/
Filter---_
(
Wash the secondary filter in warm soapy
water, rinse and dry thoroughly by squeez-
ing the filter in your hand and letting it air
dry,
DO NOT wash in the dishwasher.
DO NOT install damp.
Replace dry secondary filter, Ensure filter is
properly installed over filter opening
Replace the dust bin as outined in the
DUST BIN CLEANING section.
16