Setting Up Your Vcr; Making The Right Connections - JVC HR-J220U Instructions Manual

Setting Up Your VCR
Making the right connections
It's essential that your VCR be properly hooked up for proper results. Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VCR OPERATION CAN BE PERFORMED.
RF CONNECTION
[] Disconnect the TV antenna from the TV.
[] Connect the TV antenna to the VCR's ANT. IN.
[] Connect the VCR's RF OUT to the TV's antenna terminal
using the provided RF cable.
Matching Transformer
AC Power
Antenna or Cable
_ _,, F lat Feeder " ._.j
coaxial Cable
IN
(Antenna or
Cable input)
OUT
Back of VCR
AC Outlet
RF Cable
(provided)
See the "Basic Guide For VCR Connections" sheet enclosed with
this instruction manual for more information and other possible
connections.
75 ohm terminal
SELECT VCR CHANNEL (3 OR 4) !
With a standard RF connection,
the VCR sends picture and sound
signals through the connecting
cable to your TV on channel 3 or
4. The VCR's switch is pre-set to
CH3 prior to shipment. Set this
switch to CH4 in areas where
channel 3 is used for broadcasting.
Back of VCR
NOTE:
To operate the VCR with your TV using an RF
connection, it is always necessary to set your TV's
channel to the one you set the VCR to in this step.
10