Jenn-Air JDS9860CDB Use & Care Manual page 28

• Is propane gas being used?
The range may have been converted improperly. Contact a
service technician or see "Assistance or Service" section.
Surface burner makes popping noises
• Is the burner wet?
Let it dry.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Cooktop cooking results not what expected
Is the proper cookware being used?
See "Cookware" section.
Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
Is the range level?
Level the range. See the Installation Instructions.
Oven will not operate
Is the electronic oven control set correctly? See
"Electronic Oven Control" section.
Has a delay start been set? See "More Options" section.
On some models, is the Control Lock set? See "Locking
the Oven Control and Oven Door" section.
On some models, is the Sabbath Mode set? See "Sabbath
Mode" in the "Setup" section.
Oven temperature too high or too low
•
Does the oven temperature calibration need adjustment?
See "Temp Adjust" in the "Setup" section.
Display shows messages
• Is the display showing "FAULT DETECTED?" A fault has
been detected. Follow the displayed directions "PRESS
ENTER TO TRY AGAIN" or "DISABLE POWER TO CLEAR." If
the fault does not clear, reappears, or "FEATURE NOT
AVAILABLE" is displayed, call for assistance or service.
•
Is"SAb" flashing?
Oven is in Sabbath Mode. To cancel, press and hold the
SETUP pad for 5 seconds.
Self-Cleaning cycle will not operate
•
Is the oven door open? Close the oven door all the way.
• Has the function been entered? See "Self-Cleaning Cycle"
section.
•
On some models, has a delay start Self-Clean cycle been
set? See "Self-Cleaning Cycle" section.
• Has a delay start been set? See "More Options" section.
•
Is the control in Sabbath Mode? See "Sabbath Mode" in
the "Setup" section.
• Is the oven temperature above 400°F (205°C)?
Let the oven cool before using the self-clean cycle.
Oven cooking results not what expected
• Is the range level? Level the range. See the Installation
Instructions.
• Is the proper temperature set? Double-check the recipe in
a reliable cookbook.
•
Is the proper oven temperature calibration set? See "Temp
Adjust" in the "Setup" section.
• Was the oven preheated? See "Bake," "Broil," or "Convect
Bake" section.
• Is the proper bakeware being used? See "Bakeware"
section.
• Is the oven vent blocked? See "Oven Vent" section.
• Are the racks positioned properly? See "Positioning Racks
and Bakeware" section.
• Is there proper air circulation around bakeware? See
"Positioning Racks and Bakeware" section.
• Is the batter evenly distributed in the pan? Check that
batter is level in the pan.
• Is the proper length of time being used? Adjust cooking
time.
• Has the oven door been opened while cooking? Oven
peeking releases oven heat and can result in longer cooking
times.
• Are baked items too brown on the bottom? Move rack to
higher position in the oven.
• Are pie crust edges browning early? Use aluminum foil to
cover the edge of the crust and/or reduce baking
temperature.
Broiling results not what expected
• Is there excessive smoking? Food may be too close to the
broil element or may have excessive fat. Move rack to a lower
position.
• Is the oven door closed? Close oven door to the broil stop
position.
• Was the broil element preheated? Allow broil element to
preheat for 5 minutes.
Ventilation system not capturing smoke efficiently
Is there proper cross ventilation in the room or makeup
air?
See the Installation Instructions.
• Is the outside wall cup shut or blocked?
• Was the range and air filter installed properly?
See the Installation Instructions.
28