Troubleshooting Chart - Kobalt Air compressor Operator's Manual

I [@Z_,_ TROUBLESHOOTmNG CHART 1
Note: Troubleshooting problems may have similar causes and solutions.
PROBLEM POSSIBLE CAUSE SOLUTION
=
Low pressure or not Tank petcock is open Close petcock
enough air Prolonged excessive use of air Decrease amount of air used.
or
Compressor does not Compressor not large enough Check air requirement of accessory. Lf it is higher than CFM and
stop pressure supplied by compressor, you need a rarger compressor.
Most accessories are rated at 25% of actual CFM while running
continuously.
Restricted check valve Remove and clean or replace.
Excessive starting and
stopping, while not in
use
Hole in air hose
Tank leaks
Blown seals
Valve leaks
Fittings leak
Air leaks from regulator,
or regulator does not
regutate pressure
Regulated pressure
gauge reading drops
when air accessory is
being used
Circuit breaker trips
(fuse Mows} too often
Overheating
Dirty or damaged regulator
internal parts.
This is normal
Compressor not large enough
Low voltage
Excessive wire length
Restricted air passages
Back pressure in pump head
Poor ventilation
Check and replace if necessary.
,i_ _lmmediately replace tank. DO NOT attempt to
repair.
Replace any faulty seals.
Replace worn parts and reassemble with new seals.
Check fittings with soapy water. Tighten or reseal leaking fittings.
DO NOT OVERTIGHTEN.
Replace worn parts and reassemble with new seals.
Replace any faulty seals.
Replace regulator or internal parts.
If pressure drops too low, adiust regulator while accessory is used.
Check air requirement of accessory. If it is higher than CFM and
pressure supplied by compressor, you need a larger compressor.
Most accessories are rated at 25% of actual CFM while running
continuously.
Furnish adequate power. If using extension cord, try without.
Consult electrician.
Contact authorized service center.
Dirty cooling surfaces
-Lea king valve
Motor stalls Low voltage
Defective pressure switch Replace pressure switch bleeder valve.
bleeder valve
Replace check valve, pressure switch bleeder valve.
Relocate compressor to an area with cool, dry and well-circulated
air.
Clean all cooling surfaces of pump and motor thoroughly.
Replace worn parts and reassemble with new seals.
Furnish adequate power.
16 200-2430